On the side wall of the closet, measure desired
shelf height and mark location. Place
support at marked height with open end touching back
wall (Supports mount directly to drywall no need to locate studs).
the holes in the support as a guide, drill
drywall plugs through the support and into drilled holes until
drywall plugs lock into place.
Insert spread pins into center of drywall plugs,
5. Cut the shelf
3/8" shorter than the width of the back wall of
the closet and place shelf in the support.
Your shelf is finished!
Locate stud in back wall. Measure
to desired shelf height and mark location.
Secure back plate to stud with wood screws.
snap the bracket into the back plate. This
conceals mounting screws for a clean finished look.
the shelf on the bracket and secure it by fastening
wood screws through the holes in the wings at the top of the
First, install one of the shelves, then position
joiner onto front edge of that shelf (countersunk holes facing
out). Next, slide the joiner until end is touching
wall/support. Screw joiner to front of shelf.
andcut adjoining shelf to length and slide
into-position. Joiner itself may be cut to fit width of adjoining